| |
Packaging:
DUREX INTERIOR SPRAY is readily available in an assortment of standard
colour schemes. Please refer to our Durex Architectural Coatings Colour
Selection Guide for more information. Custom colour matching is available
upon request at a slight
additional charge.
Coverage:
Average coverage: 13.9-18.6 m²/pail (150-200 ft²/pail)
Application:
DO NOT SUBSTITUTE NOR COMPENSATE DUREX INTERIOR SPRAY WITH WATER OR
OTHER ADDITIVES.
Thoroughly mix DUREX INTERIOR SPRAY in its' own pail before each use.
Discard all frozen materials, materials which have formed solid lumps at
the bottom of the container and materials which do not appear to be of a
homogeneous viscosity.
Substrate must be dry, solid and sound, free of weak and powdery surfaces,
free from ice, snow, dew and frost, oil, grease releasing agents and other
deleterious materials detrimental to a positive bond.
Check with Durabond Products Limited for questionable surfaces.
Application of the DUREX INTERIOR SPRAY shall be executed by a team of at
least 2 tradesmen. While one tradesman sprays the coating on the wall the
second tradesman following shall supply the coating material to the
applicator and shall ensure that all masking remains in place.
The process of applying the DUREX INTERIOR SPRAY coating shall be
continuous from the starting point to a natural break point, such as
expansion/control joints and corners. Apply DUREX INTERIOR SPRAY using a
Goldblatt pattern pistol and compressor, or equivalent equipment. Final
texture will be affected by the viscosity of the coating, the type of
spray gun and size of orifice used and the amount and velocity of air
delivered by the compressor. Set up spraying equipment to Durabond's
recommendations and test apply the coating in a small area to match the
approved mock-up sample.
DO NOT BEGIN APPLICATION BEFORE EQUIPMENT HAS BEEN PROPERLY SET UP.
Apply the DUREX INTERIOR SPRAY in minimum two (2) light coats. Hold the
spray gun perpendicular, between 450 mm - 600 mm (18" to 24") away from
the substrate surface. Apply first light coat evenly throughout at a rate
of 1.3 m²/litre (60 ft²/gal.). Allow a minimum of 15 minutes drying time
between coats, depending on ambient conditions. Repeat application until
desired texture has been achieved. Movement of the spray gun during the
application process shall be smooth, steady and continuous to achieve an
even texture throughout. Avoid excessive build up in anyone area. Final
coat coverage shall not be more than 0.6 m²/litre (30 ft²/gal.). Allow a
minimum of 24 hours for final full curing. Prevent rapid evaporation.
|
 |
Lightweight Texture Plaster Finish
Product Description:
DUREX INTERIOR SPRAY is a high build, multicoloured,
interior decorative coating consisting of quartz aggregates embedded in a
100% acrylic resin.
Uses:
DUREX INTERIOR SPRAY is used as an effective long wearing
protective & decorative coating over all types of solid interior surfaces
such as gypsum board, cement board, plaster, concrete block, poured
concrete, brick and others. DUREX
INTERIOR SPRAY is mixed to match selected colours.
Advantages:
- Exceptional durability
- Excellent water repellency; protects surfaces
from moisture penetration
- Breathable coating; allows water vapour within
the wall system to evaporate
- Excellent adhesion to various substrates
- Colourfast
- Easy to clean
|
| |
Download More Information |
| |
|
|
